Overview
This article gives you the information about the saw link macro.
Below is a simple saw macro that will generate files for saws from any / all of:
- Emmegi
- FOM
- Elumatec
- Mecal
- Tekna
- Tiger
- Yilmaz
- Ozcelik
- Ozgenc
- NCX
- Pertici
Limitations:
- This macro currently only supports output in metric
- This macro does not support Quote Breakdowns
- This macro is not compatible with 3.6 and below
- Groups are technically not supported, but you can just optimize a group and save it then use the last cut plan option to output data on that group.
FAQ's:
1. Is this new version specific to 3.70, or will it work with earlier versions too?
Ans: It will only work for 3.7 (and 3.8)
2. Does this new version support mm and inches, or just mm?
Ans: It only supports metric system i.e mm
3. What does the "Last Cut Plan/Off Cuts" option do?
Ans: This option takes the last optimized cut plan for the quote and outputs the data on that.
Please contact support@softtech.com if you require assistance with this macro.